A-Pillar gage units are most ordinarily utilized as a part of today’s autos, and give customization options to further pimp out your EVO X! It’s really genuinely simple to introduce and isn’t drawn out. All that is needed are a situated of needle nose forceps and a ratchet wrench with 10 mm attachment.
- Detach the negative battery terminal utilizing the 10 mm ratchet wrench.
- From the driver’s side, remove the door trim panels. Pull upwards to release clips.
- You’ll have to remove the dash trim panels. To get to them, first evacuate the entryway weatherstripping. Note: The weatherstripping’s not glued in or anything. Try not to remove it totally. Pull it out to where it frames a large loop at the side of the driver’s side door.
- Remove the driver’s side kick panel utilizing two hands, one on the upper right corner of it and the other at the base left corner, to discharge the slide and tree push clip, and a push clip/nut.
- On the driver’s side, remove the dash trim by holding onto a tab edge that is standing out and draw to discharge the board.
- Position both hands ontop of the A-pillar gage unit while sitting in the driver’s seat and pull towards the passenger’s side of the car.
- Using a set of needle nose pliers, release the heavy plastic strap at the highest point of the A-column by snatching the dark “T” toward the end of the overwhelming plastic strap and bending it through the space opening.
- Pull the A-pillar at the top towards the traveler’s side around 3 inch additional.
- Pull the A-pillar from the base and towards you while sitting in the driver’s seat. This will release the A-Pillar. As you draw it towards you, pull marginally upwards all the while.
- Repeat the steps in reverse to introduce your new A-pillar gauge pod!